Asante-technologies 10NIC-PCITM Uživatelský manuál stáhnout pdf (Strana 24)

Page 3-8

Installing Network Drivers

PC Networks

This section explains how to install network speciﬁc drivers on PCs.

Installing the Novell NetWare 3.x Client

This section shows you how to install Novell NetWare version 3.x ODI client

software.

Create a directory named NETWARE on your C: drive.

To do this, type the following command at the DOS com-

mand line prompt:

MD C:\NETWARE

Insert either the NetWare WSGEN disk that came with Net-

Ware 3.x or your master workstation disk into drive A.

Copy the following three ﬁles to the NETWARE directory

on your C drive:

❏ LSL.COM

❏ IPXODI.COM

❏ NETX.COM

▲ Important! The Asanté 10NIC-PCI adapter requires

LSL.COM version 2.10 or later. Please check the version

number of your LSL.COM ﬁle.

Remove the NetWare WSGEN or master workstation disk

from the ﬂoppy drive.

Insert the Asanté Driver Disk into ﬂoppy drive A.

Copy the NET.CFG and the ODI driver ﬁles to the NET-

WARE directory on your C drive.

To do this, type the following two lines:

COPY A:\NETWARE\NW3.X\CLIENT\NET.CFG C:\NETWARE

COPY A:\NETWARE\NW3.X\CLIENT\ASANTPCI.COM C:\NETWARE

Check your CONFIG.SYS ﬁle to make sure that the follow-

ing line appears:

DEVICE=C:\DOS\SETVER.EXE

If you don’t see it there, type it in, then save the ﬁle.

▲ Important! The SETVER.EXE ﬁle must be in the

C:\DOS directory.

Remove the Driver Disk from the ﬂoppy drive.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 49 50

Žádné komentáře

Asante-technologies 10NIC-PCITM Uživatelský manuál Strana 24